PDI Alternative ASME Calibration Block 3 Set (Metric Version)

PDI Alternative ASME blocks are manufactured in accordance with the requirements of the Performance Demonstration Initiative (PDI) Procedure No. PDI-UT-1, Rev. C, Fig. 4 (Ferritic) and PDI-UT-2, Rev. C, Fig. 4 (Austenitic). These cover the generic procedures for the ultrasonic examination of both ferritic and austenitic pipe welds. The blocks offer an economical alternative to fabricating multiple curved calibration blocks (pipe sections) in numerous diameters and wall thicknesses.

The blocks are normally supplied in sets of 3 individual blocks; one in A516 Grade 70 Steel, one in Type 304/304L Stainless Steel, and one in Type 316/316L Stainless Steel.

Overall block dimensions – 50mm wide x 57mm tall x 250mm long. 

Block design consists of steps simulating wall thicknesses measuring 12.5mm, 25mm, 38mm and 50mm. Each step contains a 0.25mm wide EDM notch, machined across the width of the step at a depth of 10% of wall thickness. Scanning surfaces and reflecting surfaces. Are machined to simulate pipe and plate surfaces of 250 Ra max finish. Each block is machine-engraved on one side with the Block description, Serial No., Alloy. All blocks are made from ultrasonically inspected.

Material: ASME SA516 Gr 70, STAINLESS STEEL 304/304L, STAINLESS STEEL 316/316L.

Note: For special alloy request by mail.